rsxturbo seriously all u say is ill beat both yea wow u have like 250whp and 190 torque my srt-4 has more than that on stock turbo with bolt-ons

That WG is killing you man, get rid of it!

Yeah, I now have the forward motion WG and its sweet. I've changed my setup since racing my buddy wich was a long time ago. I say open that downpipe up, trash that POS stage 2 WG and get a PTP or FM WG, Get rid of those codes cause they most likely are hurting performance and race him again and see the difference. Also Do a boost leak test and make sure your not leaking any where(specially that hot side pipe and vacume lines). I have stage 2 injectors also and Im at 20psi and I raced my boy in his cobalt again for kicks like 4 months ago and it wasnt even close with 2 people in my car and 1 in his.You dont even need HOM.

how much power in both?

U can see once da srt hit 4th gear it just didnt pull as hard as it started off in 3rd! gotta change out the Wastegate for a better one!! Then it should be good!

Orangeblast srt-4 Was on Pump gas HOM did not hold. But i just put on a BFMIC, and gettin a AGP CAI anyday now bought it used for 60 bucks, and going to change my stg2 wga for a Forward Motion one! then i could take down these stg2+ Cobalts!!

I'll beat both

Yeah "CID" I think your clueless on this one buddy. A map clamp isnt going to change anything dealing with psi. Was the stage 2 on high octane mode? I beat my friends stage 2 Cobalt but he had a 2.7 pulley over stage 2's 2.8 and intake and I beat this guy by a headlight literally. I had the usual bolt ons intake,exhaust,clamp,19psi, BFM intercooler, Wastegate, plugs and wires..... Stage 2 cobalts are pretty stout from a roll. Not to consider there rev limiter is bumped up to 7k with stage 2. But I would think stage 2 SRT's on HOM would be closer of a race.

Thw SRT-4 lost, sad car

CID you have no clue what your talking about. haha