660 rwhp Mach 1 Dyno

Views: 3,265
+
=
Kudos: 72
Comments (15)
blbarnha
July 19, 2008
Send Message
 
Trust me she was no fun to drive..roasting the tires at 85mph on Drag Radials. So i bought some 10.5 inch fr500s for the rear and 9 inch for the front.......Then sold the car about a month later.
03machwon
June 23, 2008
Send Message
 
I luv the car, but good luck putting all that power to the ground on 8in wide rims.
blbarnha
March 20, 2008
Send Message
 
no... see a few pages back for full motor write up
03slickvic
March 20, 2008
Send Message
 
is that a stock short block?
armensti22
March 13, 2008
Send Message
 
Selling 2 12 inch BRAND NEW boss sub woofers and an amplifier. both sub woofers together have a peak power of 2400watts. if your interested email me at armensti@yahoo.com for piks and more info. if i were you i would email me as soon as possible because im not going to have this deal for to long and im also running out of supplies.
CraigB
March 09, 2008
Send Message
 
ya im running Maf.ia on mine as well..
blbarnha
March 09, 2008
Send Message
 
yes blowthru with an sct2400 and a maf.ia extender.
CraigB
March 09, 2008
Send Message
 
Sweet.. blowthru system??
blbarnha
March 08, 2008
Send Message
 
Its not a turbo. Its a D1 procharger (supercharger). The motor has been bored .020 over. Forged rods and pistons. The top end has a little work, valve job and stage 3 crower blower cams and springs that match. As for the fuel, i am just running pump gas with no spray, but when i get out run (and i know i will someday) there will be some nitrous! Thanks for all the compliments. Just so you guys know the fuel system is lacking a bit. I am in the process of replacing the FPDM and fuel lines and possibly the rails. After this gets done i should be really close to 700 if not just a bit over!
blbarnha
March 07, 2008
Send Message
 
Its not a turbo. Its a D1 procharger (supercharger). The loud air you hear is the race bypass. The motor has been bored .020 over. Forged rods and pistons. The top end has a little work, valve job and stage 3 crower blower cams and springs that match. As for the fuel, i am just running pump gas with no spray, but when i get out run (and i know i will someday) there will be some nitrous! Thanks for all the compliments. Just so you guys know the fuel system is lacking a bit. I am in the process of replacing the FPDM and fuel lines and possibly the rails. After this gets done i should be really close to 700 if not just a bit over!
blbarnha
Videos: 1
Photos: 0
Subscribers:0
0
Added: Mar 06, 2008
Mach 1 with D1 procharger, built bottom end, cams and a valve job.
Sponsored Links